Hydraulic Specifications - Genie S-60 TraX Service Manual

December 2013

Hydraulic Specifications

Hydraulic Oil Specifications
Hydraulic oil type Chevron Rando HD MV equivalent
Approximate SAE grade
Viscosity index rating
Cleanliness level, minimum
Water content, maximum
Chevron Rando HD MV oil is fully compatible and
mixable with Shell Donax TG (Dexron III) oils.
Genie specifications require hydraulic oils which are
designed to give maximum protection to hydraulic
systems, have the ability to perform over a wide
temperature range, and the viscosity index should
exceed 140. They should provide excellent antiwear,
oxidation, corrosion inhibition, seal conditioning, and
foam and aeration suppression properties.
Optional fluids
Biodegradable
Fire resistant
Mineral based
Continued use of Chevron Aviation
A hydraulic oil when ambient
temperatures are consistently
above 32°F / 0°C may result in
component damage.
Continuous improvement of our products is a
Genie policy. Product specifications are subject
to change without notice.
Part No. 147753
5W-20
200
15/13
200 ppm
Petro Canada Environ MV46
Statoil Hydra Way Bio Pa 32
BP Biohyd SE-S
UCON Hydrolube HP-5046
Quintolubric 822
Shell Tellus S2 V 32
Shell Tellus S2 V 46
Chevron Aviation A
ARNICA 32
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
Note: Use Chevron Aviation A hydraulic oil when
ambient temperatures consistently below
0°F / -18°C.
Note: Use Shell Tellus T46 hydraulic oil when oil
temperatures consistently exceed 205°F / 96°C.
Note: Genie specifications require additional
equipment and special installation instructions for
the approved optional fluids. Consult the Genie
Service Department before use.
Drive pump
Type:
Flow rate @ 2500 rpm
Drive pressure, maximum
Charge pump
Type:
Displacement
Flow rate @ 2500 rpm
Charge pressure @ 2500 rpm
Function pump
Type:
Displacement - Pump 1 (inner)
Flow rate @ 2500 rpm
Displacement - Pump 2 (outer)
(oscillate models)
Flow rate @ 2500 rpm
Section 2 • Specifications
SPECIFICATIONS
bi-directional, variable
displacement piston pump
32.4 gpm
122.6 L/min
3750 psi
259 bar
gerotor
0.85 cu in
13.9 cc
9.2 gpm
34.8 L/min
310 psi
21.4 bar
2 section tandem gear pump
1.4 cu in
23 cc
15.3 gpm
58 L/min
0.24 cu in
4 cc
2 gpm
7.6 L/min
2 - 3