Genie S-60 TraX Service Manual page 112

Section 4 • Repair Procedures
PLATFORM CONTROLS
12 Repeat steps 9 through 11 for each joystick
controlled machine function.
13 Return the joystick to the neutral position and
wait for approximately 10 seconds to allow the
settings to be saved.
Result: The alarm should sound indicating that
the settings have been saved in memory.
Result: The alarm does not sound. The
minimum or maximum adjustment has been
obtained. No changes can be saved.
Note: Do not operate any machine function during
the 10 second waiting time.
14 Cycle the red Emergency Stop button off, then
back on.
4 - 6
How to Adjust the Joystick
Ramp Rate Setting
The ramp rate setting of a joystick controls the time
at which it takes for the joystick to reach maximum
output, when moved out of the neutral position. The
ramp rate settings of a joystick can be changed to
compensate for hydraulic pump wear to maintain
peak performance from the machine.
Note: Perform this procedure on a firm, level
surface.
1 Pull out the red Emergency Stop button to the
2 Turn the key switch to platform control. Do not
3 Push in the platform controls red Emergency
4 Do not press down the foot switch.
5 Move and hold the drive enable toggle switch in
6 When the alarm sounds, release the drive
7 Momentarily activate the drive enable toggle
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
on position at both the ground and platform
controls.
start the engine.
Stop button to the off position.
the right position and pull out the red
Emergency Stop button to the on position.
enable toggle switch.
switch in the right direction 6 times.
Result: There should be a pause and the alarm
should sound 6 times indicating that the
machine is in ramp rate calibration mode.
Result: The alarm does not sound. Repeat steps
3 through 7.
December 2013
Part No. 147753