Traction Manifold Components, 4Wd (After Sn 21231) - Genie S-60 TraX Service Manual

Section 4 • Repair Procedures
MANIFOLDS
7-13

Traction Manifold Components, 4WD (after SN 21231)

The traction manifold is mounted inside the drive chassis at the non-steer end.
Index
No. Description
1 Flow divider/combiner valve ............. XX ......... Controls flow to non-steer end
2 Relief valve, 280 psi / 19.3 bar ......... UU ........ Charge pressure circuit .................... 35-40 ft-lbs / 14-16 Nm
3 Check valve ....................................... TT ......... Steer end drive motor circuit ............ 35-40 ft-lbs / 14-16 Nm
4 Flow divider/combiner valve ............. AB ......... Controls flow to flow
5 Orifice, 0.040 inch / 1 mm .................. WW ....... Equalizes pressure on both sides
6 Orifice, 0.040 inch / 1 mm .................. AE ......... Equalizes pressure on both sides
7 Orifice, 0.040 inch / 1 mm .................. AC ........ Equalizes pressure on both sides
8 Check valve ....................................... SS ......... Non-steer end drive motor circuit ..... 35-40 ft-lbs / 14-16 Nm
9 Check valve ....................................... AF ......... Non-steer end drive motor circuit ..... 60-70 ft-lbs / 81-95 Nm
10 Check valve ....................................... ZZ ......... Steer end drive motor circuit ............ 35-40 ft-lbs / 14-16 Nm
11 Check valve ....................................... AG ........ Steer end drive motor circuit ............ 60-70 ft-lbs / 81-95 Nm
12 Shuttle valve, 3 position 3 way ......... VV ......... Charge pressure circuit that
13 Flow divider/combiner valve ............. AD ........ Controls flow to steer end
14 Check valve ....................................... YY ......... Non-steer end drive motor circuit ..... 35-40 ft-lbs / 14-16 Nm
4 - 62
Schematic
Item Function
drive motors in forward
and reverse ................................... 80-90 ft-lbs / 108-122 Nm
divider/combiner valves
1 and 13 ........................................ 80-90 ft-lbs / 108-122 Nm
of flow divider/combiner valve 1
of flow divider/combiner valve 13
of flow divider/combiner valve 4
directs hot oil out of low pressure
side of drive pump ........................ 80-90 ft-lbs / 108-122 Nm
drive motors in forward
and reverse ................................... 80-90 ft-lbs / 108-122 Nm
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
December 2013
Torque
Part No. 147753