Drive Oil Diverter Manifold (Welder Option) - Genie S-60 TraX Service Manual

December 2013
7-9
Drive Oil Diverter Manifold Components (welder option)
The oil diverter manifold is mounted to the hydraulic generator located in the engine compartment.
Index
No. Description
1 Directional valve ............................ CU ........... Diverter valve ............................... 80-90 ft-lbs / 108-122 Nm
2 Orifice disc, 0.030 inch / 0.080 cm . CV ........... Delays shift to drive
3 Solenoid valve ............................... CW .......... Pilot valve to diverter ....................... 35-40 ft-lbs / 47-54 Nm
4 Relief valve .................................... CX ........... Charge pressure circuit ................... 35-40 ft-lbs / 47-54 Nm
5 Pressure switch 200 psi / 18.6 bar . CZ ........... Generator relay switch ................................ 16 ft-lbs / 22 Nm
6 Connector fitting ...................................................................................................................... 11 ft-lbs / 15 Nm
7 Check valve .................................... CY ........... Prevents oil to generator ................. 35-40 ft-lbs / 47-54 Nm
CY
7
6
CZ
5
Part No. 147753
Schematic
Item Function
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
Section 4 • Repair Procedures
MANIFOLDS
Torque
CV
CU
1
2
CW
3
CX
4
4 - 57