Perkins 404-22 Engine Specifications - Genie S-60 TraX Service Manual

December 2013
Perkins 404-22 Engine
Displacement
Number of cylinders
Bore and stroke
Horsepower
Firing order
Low idle
High idle
Compression ratio
Compression pressure
Pressure (psi) of lowest cylinder must
be within 50 psi / 3.45 bar of highest cylinder
Governor
Valve clearance, cold
Intake
Exhaust
Continuous improvement of our products is a
Genie policy. Product specifications are subject
to change without notice.
Part No. 147753
134 cu in
2.2 liters
4
3.31 x 3.94 inches
84 x 100 mm
51 @ 2500 rpm
38 kW @ 2500 rpm
1 - 3 - 4 - 2
1300 rpm
229.7 Hz
2500 rpm
441.7 Hz
23.3:1
426 psi
29.4 bar
centrifugal mechanical
0.008 in
0.2 mm
0.008 in
0.2 mm
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
Lubrication system
Oil pressure, cold
(at 2500 rpm)
Oil capacity
(including filter)
Oil viscosity requirements
Below 86°F / 30°C
-4°F to 104°F / -20°C to 40°C
Above 14°F / -10°C
Units ship with 15W-40.
Extreme operating temperatures may require the use of
alternative engine oils. For oil requirements, refer to the
Engine Operator Handbook on your machine.
Oil pressure sending unit
Oil pressure switch point
Fuel injection system
Injection pump make
Injection pressure
Fuel requirement
For fuel requirements, refer to the engine Operator's
Manual on your machine.
Alternator output
Fan belt deflection
Starter motor
Current draw, no load
Brush length, new
Brush length, minimum
Section 2 • Specifications
SPECIFICATIONS
60 psi
4.1 bar
9.3 quarts
8.8 liters
5W-20
10W-30
15W-40
14.2 psi
1 bar
Zexel
2133 psi
147 bar
55A @ 12V DC
3
/
8
10 mm
90A
0.7480 in
19 mm
0.5 in
12.7 mm
2 - 11
in