Check The Exhaust System - Genie S-60 TraX Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
4 Inspect the following areas for burnt, chafed,
corroded and loose wires:
• Engine wiring harness
• Hydraulic manifold wiring
5 Open the ground controls side turntable cover.
6 Inspect the following areas for burnt, chafed,
corroded and loose wires:
• Inside of the ground control box
• Hydraulic manifold wiring
7 Inspect for a liberal coating of dielectric grease
at the following location:
• All wire harnesses connectors to the
ground control box
8 Start the engine from the ground controls and
raise the boom above the turntable covers.
9 Inspect the turntable area for burnt, chafed and
pinched cables.
10 Lower the boom to the stowed position and turn
the engine off.
11 Inspect the following areas for burnt, chafed,
corroded, pinched and loose wires:
• Cable track on the primary boom
• Cables on the primary, and jib booms
• Jib boom/Platform rotate manifold
• Inside of the platform control box
12 Inspect for a liberal coating of dielectric grease
at the following location:
• All wire harnesses connectors to the
platform control box
13 Swing the engine back to its original position
and install the engine tray retaining fastener.
3 - 22
B-3

Check the Exhaust System

Genie specifications require that this procedure be
performed every 250 hours or quarterly, whichever
comes first.
Maintaining the exhaust system is essential to
good engine performance and service life. Running
the engine with a damaged or leaking exhaust
system can cause component damage and unsafe
operating conditions.
1 Remove the engine tray retaining fastener
2 Install the fastener that was just removed
3 Be sure that all nuts and bolts are tight.
4 Inspect all welds for cracks.
5 Inspect for exhaust leaks; i.e., carbon buildup
6 Swing the engine back to its original position
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
Bodily injury hazard. Do not
inspect while the engine is running.
Remove the key to secure from
operation.
Burn hazard. Beware of hot engine
components. Contact with hot
engine components may result in
severe burns.
located under the engine tray.Swing the engine
tray out and away from the machine.
through the engine tray and into the engine tray
anchor hole in the turntable.
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
around seams and joints.
and install the engine tray retaining fastener.
December 2013
Part No. 147753