Genie S-60 TraX Service Manual page 100

Section 3 • Scheduled Maintenance Procedures
CHECKLIST D PROCEDURES
5 Install the new filter element into the filter
housing.
6 Push the filter element down to be sure the
O-ring on the element is fully seated into the
housing.
7 Rotate the filter element clockwise to lock it in
place.
8 Install the filter housing cap.
9 Use a permanent ink marker to write the date
and number of hours from the hour meter on the
oil filter housing.
Medium and high pressure filters:
Note: The medium pressure filter is for the charge
pump and the high pressure filter is for all machine
functions except the drive circuit and oscillating
axle circuit.
10 Open the engine side turntable cover and locate
the medium and high pressure filters near the
pump.
Note: The medium pressure filter is located on the
right. The high pressure filter, with filter condition
indicator, is located on the left.
11 Place a suitable container under each filter.
12 Remove the filter housings by using a wrench on
the nut provided on the bottom of the housings.
13 Remove the filter elements from the housings.
14 Inspect the housing seals and replace them if
necessary.
3 - 62
15 Install the new filter elements into the housings
Note: The medium and high pressure filters use the
same elements.
16 Clean up any oil that may have spilled during the
17 Use a permanent ink marker to write the date
18 Start the engine from the ground controls.
19 Inspect the filter housings and related
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
and tighten them securely.
installation procedure.
and number of hours from the hour meter on the
oil filter housings.
components to be sure that there are no leaks.
December 2013
Part No. 147753