Genie S-60 TraX Service Manual page 122

Section 4 • Repair Procedures
PLATFORM COMPONENTS
6 Start the engine from the ground controls.
7 Raise the boom until the distance, when
measured between the centers of the pivot pins
shown, equals 108.75 inches / 276 cm
± 0.75 inch / 19 mm.
Crushing hazard. Keep clear of all
moving parts of the boom while the
boom is raising. Do not attempt to
measure between the pivot pins
while the boom is moving.
Operational Control Module LED Status
Description
Green AND Red LED's
not flashing
Green LED
flashing rapidly
Red LED flashing
with pauses
Safety Control Module LED Status
Description
Green AND Red LED's
not flashing
Green AND Red LED's
flashing alternately
4 - 16
Measure between
the centers of these
pivot pins
Definition
System calibrated
System in calibration
mode
Indicates next calibration
step (ie; 2, 3, etc.)
Definition
System calibrated
System not calibrated
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
8 Activate the calibration toggle switch inside the
ground control box 1 time.
Result: The alarm should sound for 1 second
indicating the second calibration step was
accepted. The green LED on the operational
controller should be blinking fast and the red
LED should be blinking three times indicating
that step 3 of calibration is next.
9 Raise the boom until the distance, when
measured between the centers of the pivot pins
shown, equals 167.25 inches / 424.8 cm
± 0.75 inch / 19 mm.
Crushing hazard. Keep clear of all
moving parts of the boom while the
boom is raising. Do not attempt to
measure between the pivot pins
while the boom is moving.
10 Activate and release the calibration toggle
switch inside the ground control box 1 time.
Result: The alarm should sound for 1 second
indicating the third calibration step was
accepted. The green LED on the operational
controller should be blinking fast and the red
LED should be blinking four times indicating that
step 4 of calibration is next.
11 Fully raise and extend the boom.
December 2013
Part No. 147753