Genie S-60 TraX Service Manual page 136

Section 4 • Repair Procedures
BOOM COMPONENTS
8 Remove the cable guard fasteners and remove
the cable guard.
a
a cable guard
b retaining block
9 Locate the retaining plates that secure the
retract cables to the inside of the number 3
boom tube.
10 Remove the cable retaining plates and pull the
retract cables off of the pulleys. Lay the cables
flat and out of the way.
11 Remove the fasteners from the retaining blocks
from the extension cylinder saddle. Remove the
blocks.
Note: Access the fasteners through the access
hole in the outer boom tube at the pivot end.
4 - 30
b
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
12 Disconnect the wire connector to the extend
cable break limit switch.
13 Remove the retaining fasteners that secure the
extend cable mounting plates to the inside of
the number 1 boom tube.
a b c
a extend cable lock nuts
b extend cable mounting plate
c extend cable mounting plate fastener
d extend cable bracket
14 Pull back on the extend cable mounting plate
until it clears the blocks welded to the inside of
the number 1 boom tube.
December 2013
d
Part No. 147753