Replace The Drive Hub Oil - Genie S-60 TraX Service Manual

December 2013
8 Fully retract the boom and raise the boom to full
height. Visually inspect the dial indicator to be
sure the needle returns to the "zero" position.
9 Remove the dial indicator and rotate the
turntable 90°.
10 Repeat steps 4 through 9 until the rotation
bearing has been checked in at least four
equally spaced areas 90° apart.
11 Lower the boom to the stowed position and turn
the machine off.
12 Remove the dial indicator from the machine.
Part No. 147753
D-4

Replace the Drive Hub Oil

Genie specifications require that this procedure be
performed every 1000 hours or annually, whichever
comes first.
Replacing the drive hub oil is essential for good
machine performance and service life. Failure to
replace the drive hub oil at yearly intervals may
cause the machine to perform poorly and continued
use may cause component damage.
S-60, S-65, S-60 HC, S-60X and S-60XC:
1 Select the drive hub to be serviced. Drive the
2 Remove both plugs and drain the oil into a
3 Drive the machine until both plugs are
4 Fill the hub until the oil level is even with the
5 Install the plugs into the drive hub.
6 Check the torque of the drive hub mounting
7 Repeat this procedure for each drive hub.
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
Section 3 • Scheduled Maintenance Procedures
CHECKLIST D PROCEDURES
machine until one of the two plugs is at the
lowest point.
suitable container.
horizontal.
a drive hub plugs
bottom of the plug hole. Refer to Section 2,
Specifications.
bolts. Refer to Section 2, Specifications .
a
3 - 57