Genie S-60 TraX Service Manual page 178

Section 4 • Repair Procedures
TRACK COMPONENTS
6 Install the new track onto the undercarriage.
7 Attach a lifting strap from an overhead crane to
the center-point of the track, above the
sprocket.
8 Use the overhead crane to raise the track
assembly to an upright position. Rest the
assembly on the floor or ground to remove any
slack in the lower portion of the track.
Note: Be sure the idler and bogey wheels are
aligned with the inside surface of the track.
a
b
a idler wheels
b bogey wheels
4 - 72
9 Rotate the sprocket half until the split tooth of
10 Using an overhead crane or other suitable lifting
11 Install the sprocket half, removed in step 3,
a
Note: Be sure to align the split tooth in both of the
sprocket halves.
12 Insert a pin or rod through the wheel stud hole
13 Insert a pointed pry bar into the wheel stud hole
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
the sprocket is lower than the other side.
a
a split tooth
device, lift up on the rubber track to create
enough room to install the other sprocket half.
while engaging the sprocket teeth with the
rubber track.
closest to the split tooth to hold the sprocket in
place.
near the top of the sprocket. Insert another
pointed pry bar into the wheel stud hole at the
opposite side of the split tooth.
December 2013
Part No. 147753