Inspect The Engine Air Filter - Genie Z80/60 Service Manual

June 2011
REV G
2 Locate the engine tray anchor hole at the pivot
end of the engine tray.
3 Install the bolt that was just removed into the
anchor hole to secure the engine tray from
moving.
Crushing hazard. Failure to install
the bolt into the engine tray to
secure it from moving could result
in death or serious injury.
4 Be sure that all nuts and bolts are tight.
5 Inspect all welds for cracks.
6 Inspect for exhaust leaks (i.e., carbon buildup)
around seams and joints.
7 Remove the engine tray retaining fastener from
the engine tray anchor hole at the pivot end of
the engine tray.
8 Swing the engine tray in towards the machine.
9 Install the bolt that was just removed into the
original hole to secure the engine tray.
Crushing hazard. Failure to install
the bolt into the engine tray to
secure it from moving could result
in death or serious injury.
Part No. 88619
Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
B-5

Inspect the Engine Air Filter

Genie requires that this procedure be performed
every 250 hours or quarterly, whichever comes
first. Perform this procedure more often if dusty
conditions exist.
Note: Perform this procedure with the engine off.
1 Open the engine side cover. Empty the dust
discharge valve by pressing together the sides
of the discharge slot. Clean the discharge slot
as needed.
a
b
c
a
b
c
2 Disconnect the retaining clamp from the air
cleaner canister.
3 Remove the filter element.
4 Clean the inside of the canister and the gasket
with a damp cloth.
5 Inspect the air filter element. If needed, blow
from the inside out using low pressure dry
compressed air, or carefully tap out dust.
6 Install the filter element.
7 Install the air filter canister end cap and connect
the end cap retaining clamp.
Z-80/60
retaining clamp
canister end cap
dust discharge valve
3 - 23