1 Nov. '87
2. DEVELOPMENT
2-1 DEVELOPER REPLACEMENT
Take care not to damage the upper brush seal.
After removing used developer, clean the drive gears.
Open the front cover, loosen the development retainer plate (1 screw),
raise the development lock lever and pull out the development unit.
Separate the toner tank [A] from the development unit [B] (2 screws).
Remove the development brush cover [C] (2 screws) and clean it.
Set the development unit on a large sheet
downwards.
Empty the development unit by turning
counterclockwise.
of paper with the inlet facing
the paddle roller knob [D]
3-10
.