Table of Contents
Advertisement
1 Nov. '87
4 .
Remove the corona wire [E] from the front end block first.
Hook the tension spring [F] on to the new wire and install making sure
5
that the wire is correctly positioned in the "V" slot [G].
Reassemble the wire cleaner, and then the end block covers.
6
11 .
T/S Corona Wires.
1 .
Remove the corona paper guide [H] by pressing the stopper and pulling
it towards the rear.
2 .
Remove the rear end block cover [1].
Remove the corona wires [J] by pulling the front end blocks [K] towards
3
the front and lifting upwards. (See illustration.)
Replace the corona wires, making sure they are correctly positioned in
4 .
the "V" slots [L].
NOTE: Take care not to damage the transfer entrance mylar during this pro-
cedure.
1
4
3-52
Advertisement
Table of Contents
