conditions'. Be careful not to leave the lamp on for a long time.
#2
When the exposure lamp is turned on, after 20 seconds, auto-
shut off occurs.
original ID sensor data (Hex code) is displayed in the opera-
the
tion panel (see 9-2 Original ID Sensor Adjustment).
#3 If the scanner is in the position
the clutch only turns on for a short time.
#4 When the bias amounts are measured, they may be
than the stated amounts.
#5 After 20 seconds, auto-shut off occurs.
#6 If both the "Free Run" and "Test Mode" are turned on ("Test
Mode" has priority over "Free Run"), using this procedure will
change the copier to "Free Run".
during this operation,
(H. P.)
2-8
lower
2-6%