Table of Contents
Advertisement
5-5 REGISTRATION SENSOR
Turn off the main switch.
1
9
2 9
Open the front cover and remove the development unit.
Remove the right inner cover [A] (4 screws).
3
4 .
Uncouple the registration sensor connector [B] and snap-out the male
connector [C] from the front plate (see illustration).
5 .
Lower the transport unit and remove the T/S corona unit.
6 9
Remove the front holding pin [D] (1 screw), and remove the registration
guide [E] taking care that the guide does not full.
Remove the registration sensor [F] and bracket [G] (1 screw, 1 connec-
7 .
tor) from the registration guide [E].
8
Separate the sensor from the bracket and replace it.
NOTE: When re-installing, make sure the
correctly fitted over the rear holding
REPLACEMENT
rear of the registration guide is
pin.
3-35
1 Nov. '87
Advertisement
Table of Contents
