Table of Contents
Advertisement
Ill. Transfer Corona
1. Re-install the T/S corona unit and position the drum shoe [A] on the cen-
ter of the shaft, so that the axis of the shoe is aligned with the transfer
corona wire [B] as shown.
2. Re-install the drum stay [C] (1 screw, 1 knob).
[D]
Turn on DPS101 -5 (Test Mode) on the main PCB.
4.
5. Turn on the main switch and press 10 key
and press the "Start" key.
"4",
Note the reading.
69 Adjust the transfer corona current by turning
on the
power
"VRT"
CTB
pack [E].
7. Press the "C/S" key, turn off the main switch, and turn off DPS101-5.
3-57
Advertisement
Table of Contents
