1. Turn off the main switch and unplug the copier.
2. Remove the rear cover (2 screws) and the right cover (4 screws).
3. Remove the CTB power pack [A] (1 screw, 2 locking supports, 2 connec-
tors, 3 terminals).
4. Remove the paper feed clutch bracket [B] (2 screws, 1 wire clamp).
In order not to damage the main PCB, pull out the lower part of the
bracket first.
5. Remove the pick-up arm [C] (1 "E" ring), paper feed solenoid assembly
[D] (2 screws, 1 connector), and the feed clutch cam [E] (1 "E" ring).
3-31