Table of Contents
Advertisement
REVERSE CLUTCH DAMPER REPLACEMENT
1-6
1. Turn' off the main switch, unplug the copier, remove the rear cover (2
screws), upper cover (6 screws) and the right cover
2. Remove the main PCB
wire clamps).
3. Remove the reverse clutch damper cover
damper [B].
a) Take care that the pin [C] does not fall out of position during the
NOTE:
above procedure.
b) For easier re-installation of the reverse clutch damper cover, posi-
tion the hole in the reverse drive gear [D] as shown in the illustra-
tion, and make sure the pin is horizontal. Then install the damper
cover making sure the long stud fits into the hole of the reverse
drive gear.
screws, 19 connectors, 1 locking support, 3
(4
3-9
screws).
(4
"E" ring) and replace the
[A] (1
I
' 8 7
N o v .
1
Advertisement
Table of Contents
