Table of Contents
Advertisement
Remove the 2 bushings [D] (1 "E" ring each), and fit them on the new
5
pressure roller [E] .
6 .
Install the new pressure roller and set it in the pressure release position
by lifting the pressure levers [F] and placing two screws [G] in the un-
tapped holes (see illustration).
7 .
Remove the protective paper [H], fit the pressure springs and remove
the 2 screws from the untapped holes.
Assemble the copier.
8
NOTE: During re-assembly
positioned in the sensor grove.
make sure the oil end sensor holder is correctly
j
3-47
1 Nov. '78
I
Advertisement
Table of Contents
