Table of Contents
Advertisement
1 NOV. '87
Hook the bead [A] of the new wire in the anchorage point on the rear
7.
plate [B], and run it over the pulleys in the following order:
a) inner track of WP1
b) via the wire clamp [D] to WP2
c) inner to outer on WP3 (3 times) to WP4
d) outer track of WPI to WT.
8. Hook the tension spring [1] to its anchorage point [J].
Rotate the
NOTE:
drive wire
point.
Move the 1st and 2nd scanners to their furthermost right position (as
9
viewed from the rear
clamp.
10
Perform the horizontal
nification Adjustment).
scanner drive pulley in order to
moves smoothly and that it is
of the copier), and temporarily tighten the wire
magnification adjustment (see 9-3 Horizontal Mag-
confirm that the scanner
not over-lapping at any
3-8
.
Advertisement
Table of Contents
