Ricoh FT3320 Service Training Manual page 140

1 NOV. '87
2-2 DEVELOPMENT SET SENSOR REPLACEMENT
1. Turn off the main switch and unplug the copier.
2. Remove the development unit (see 2-1 Developer
3. Remove the main PCB (see 1-6 Reverse Clutch Damper Replacement), --
Remove the 1 screw, 2 locking supports, and CNI on the CTB power
4.
pack [A], and swing it to the right.
5. Remove the paper feed clutch bracket [B] (2 screws, 1 wire clamp).
6. Remove the development set sensor [C] and bracket [D] (2 screws, 1
connector, 1 wire clamp).
7. Separate the sensor from the bracket and replace it.
Replacement).
3-12