NEC Univerge SV8100 Features And Specifications Manual page 1740

Issue 5.0
To program a key, press Speaker, dial 751 (for 2-digit codes) or 752 (for 3-digit codes),
For this feature...
Networking
Night Service
Off-Hook
Signaling
Paging, External
Paging, Internal
Park
Repeat Redial
Reverse Voice
Over
Room Monitor
3 - 32
Table 3-4 Function Key Codes by Feature (Continued)
press the key and enter the code (e.g., 48 for Voice Over).
Use this key...
Code: 06 + network

(01~50)
Operation: Press key
Code: 09 + mode (1~4
or 1~8)
Operation: Press key
Code: 33
Operation: Call ext.
and receive busy +
Press key
Code: 19 + zone (1~8)
Operation: Press Key
Code: 20
Operation: Press key
Code: 21 + zone
(1~8, 1~9 or 01~64)
Operation: Press key
Code: 2
Operation: Press key
Code: 04 + orbit (1~9

or 01~64)
Operation: Place or
answer call + Press
key
Code: 29
Operation: Place call
and press key
Code: 47 + dest. ext.
Operation: Press and
hold key
Code: 39
Operation: Press key
at destination & source
+ ext
When you ...
Access a networked trunk.
Activate the Day/Night
Mode.
Signal a busy extension.
Make an external zone
page.
Make an external All Call
page.
Broadcast to an Internal
Paging Zone.
Broadcast to all Internal
Paging zones.
Place a call into or
retrieve a call from a Park
Orbit.
Activate Repeat Redial
while on a call.
Initiate Reverse Voice
Over.
Activate Room Monitor.
UNIVERGE SV8100
Also See
Key Lamp Status
Srvc Code
None
On red when
activated
None
On red when 703 + zone
activated
On red when 703 + 0
activated
On red when 701 + zone
activated
On red when 701 + 0 or
activated
Fast flash when #6 (Park)
orbit is busy 6 (pickup)

(green at
originator, red at
others)
Fast Flash while
system waits to
redial
Full BLF red
Dest. Fast Flash
red, Source Hold
Flash red
Codes Tables
-
718 +
+ 0
7
00
-
-
-