Removing/Installing Rear Cover - Konica Minolta drypro 832 Service Manual

Chapter 3 Basic Operations
3.3.4

Removing/Installing Rear Cover

This section describes how to remove/install the rear cover.
Be sure to turn off power and remove the power cable from the electrical outlet before removing
or installing the exterior cover or replacing loading parts.
Caution
Removal Procedure
This is the end of the process of removing the rear cover.
3-18
1
Pull the tray shutter out of the lower part of the
supply tray.
2
Insert the tray shutter into the slot in the upper
part of the supply tray with the tray shutter's UP
mark on the top surface toward you.
Inserting the tray shutter as far as it will go unlocks and
causes it to pop out several centimeters.
•
When replacing loading parts, be sure to
replace with the tray shutter attached.
Caution
If some of the film remains on the tray, the
film may be exposed.
•
Take sufficient care when handling the
tray shutter, as it may be impossible to
insert if it becomes deformed due to
rough handling.
•
If you feel any resistance when inserting
the tray shutter, stop the procedure and
refer to "17.1.7 Pickup malfunction
trouble (Page 17-6)"
3
Remove the rear cover.
• Six screws (M4×8)
Remove the upper two screws and the one screw
in the center from the rear cover and loosen the
Note
bottom three.
to fix the problem.