At Steering Shift Switch - Subaru 2004 LEGACY Service Manual

AT Steering Shift Switch

CONTROL SYSTEMS
4. AT Steering Shift Switch
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Set the tire to the straight-ahead position.
3) Remove the airbag module. <Ref. to AB-14, RE-
MOVAL, Driver's Airbag Module.>
WARNING:
With the airbag module equipped, always refer
to "Airbag System" when performing the airbag
module repair service. <Ref. to AB-14, INSPEC-
TION, Driver's Airbag Module.>
4) Remove the steering wheel. <Ref. to PS-20, RE-
MOVAL, Steering Wheel.>
5) Remove the cover from steering wheel.
6) Remove each one of AT steering shift switch
mounting screw from the LH and RH side.
CS-00331
7) Remove the steering shift switch.
B: INSTALLATION
1) Clean all parts before installation.
2) Install in the reverse order of removal.
3) After completion of installation, set the select le-
ver to SPORT shift side and confirm that manual
mode "1" illuminates on the combination meter.
4) Operate the steering shift switch and confirm
that the "2" illuminates on combination meter.
CS-16