Clear Counters - Epson Stylus Pro 7710 Service Manual

Epson Stylus Pro 7700/7710/7900/7910/9700/9710/9900/9910

5.8 Clear Counters

Whenever the parts/units which have life counter are replaced, the corresponding life
counter must be reset. This is important to replace those parts/units at the correct
timing.
PROCEDURE
1. Turn the printer ON in the Serviceman Mode.
Turn the power ON while pressing [Menu
simultaneously.
2. Start the Service Program and select a target Counter Reset menu.
3. Click [Run] to reset the counter.
4. Click [Finish].
Figure 5-85. [Clear Counter] Screen
ADJUSTMENT
] + [Paper Feed ] + [OK]
Clear Counters
Table 5-3. Clear Counter Menu List
Replaced Part/Unit
INK TUBE L/R When replacing Ink tube
Wiper Cleaner Assy When replacing Wiper
When replacing Wiper
INK SYSTEM UNIT
(PUMP MOTOR)
When replacing Pump motor
PRESSURIZING UNIT When replacing Pressurizing motor
INK SELECT MOTOR When replacing Ink select motor
INK HOLDER L/R When replacing Cartridge holder (Ink Pad)
PF MOTOR When replacing PF motor
CR MOTOR When replacing CR motor
PRINTHEAD When replacing Printhead
AID BOARD When replacing AID board
Carriage Motor When replacing CR Motor
Paper Pressing Motor When replacing Paper Pressing Motor
Cooling Fan 1/2 When replacing Fans
Take care when using
C A U T I O N
function clears all the counters such as the total operating time
or the like including the parts to be replaced mentioned above.
Make sure to perform a Clear Counter for the SpectroProofer
after confirming that the SpectroProofer is in the ready state
(when the LED is on). If it is performed in the OFF or sleep
state, the counter is not reset correctly.
Clear Counters can be done in Serviceman Mode though, make
sure to perform this function using the Service Program.
Revision D
Pro
7900/
Menu Name 7910/
9900/
9910
√
√
√
√
√
√
√
√
√
√
√
√
√
√
All Counter Clear in Counter Reset. This
Pro
7700/
7710/
9700/
9710
√
√
√
√
√
–
√
√
√
√
√
–
–
–
360