Epson Stylus Pro 7710 Service Manual page 41

Epson Stylus Pro 7700/7710/7900/7910/9700/9710/9900/9910
Top Menu Menu Item
PAPER SKEW CHECK
REFRESH MARGIN
PRINTER SETUP
AUTO NOZZLE
CHECK
PRINT NOZZLE
PATTERN
INITIALIZE SETTING
NOZZLE CHECK
STATUS SHEET
TEST PRINT
NETWORK STATUS
SHEET
JOB INFORMATION
CUSTOM PAPER
PRODUCT DESCRIPTION
Table 1-6. Menu Mode Settings List
Settings
(shaded one is the default)
Sets whether to detect the paper skew or not.
ON
Setting to OFF does not carry out the detection and printing is continued even if the paper is skewed. When this
setting is set to OFF, the user should have known the risk.
OFF This setting is not available for cut sheet because the skew detection function after printing is not provided for
cut sheet.
ON
When this is set to ON, the top edge area of paper soiled by the previous borderless printing is automatically cut
off.
OFF
ON: PERIODICALLY
Sets the execution timing for the auto nozzle check. When the nozzle clogging is detected, the cleaning starts
ON: EVERY JOB
automatically. You can set the number of executions for cleaning from
OFF
OFF
The printer prints a nozzle check pattern automatically at the specified timing. This setting is available only
when roll paper is used.
ON: EVERY PAGE
When the set number of pages is reached, the nozzle check pattern is printed on the top of the page. The counter
for counting the pages is not reset even by power-off. When this setting is changed, the counter is cleared.
ON: EVERY 10 PAGES
Printing patterns preset in the printer is not counted except the network status sheet.
EXECUTE All the settings made using the control panel are returned to their default.
Prints a nozzle check pattern, the firmware version, paper/ink consumption, and waste ink level in the
PRINT maintenance tanks. Visually check the printout patterns for any missing lines or segments. If missing lines or
segments are observed, run a manual cleaning as necessary.
PRINT Prints information on the printer status.
PRINT Prints information on the network status.
PRINT Prints a print job history report (up to 10 jobs) that is stored in the printer.
PRINT
Prints the settings made in the CUSTOM PAPER menu.
Control Panel
Explanation
"1.5.2 Maintenance Mode
Revision D
Applied
model
√ √
√ √
√ √
(p51)".
√ √
√ √
√ √
√ √
√ √
√ √
√ √
42