Epson Stylus Pro 7700/7710/7900/7910/9700/9710/9900/9910
CR move
Perform this check while the mounter is installed on the printer, or
C A U T I O N
placed on a flat location.
1.
Select
CR
move.
2.
If the following screen appears, click on the [OK] button.
The Paper Pressing Plate starts operating, then the carriage starts moving.
Figure 5-101. [CR move] Screen
ADJUSTMENT
3.
Confirm that the carriage operates normally.
If not, follow the instruction below.
Symptom
Paper Pressing Plate
Check the installation status of Paper Pressing Plate.
does not operate.
Check the drive transmission path of the Carriage Motor, and if any
abnormality is found, correct it.
Check the status of the Carriage Motor, and if any abnormality is
found, correct it.
Carriage does not operate
normally.
Check the status of the timing belt, and if any abnormality is found,
correct it.
Check the status of the CR HP Sensor, and if any abnormality is
found, correct it.
Figure 5-102. Carriage Operation Check
Tests
Revision D
Remedy
(p. 281)
(p. 279)
(p. 268)
367