Epson Stylus Pro 7700/7710/7900/7910/9700/9710/9900/9910
17. Move the carriage over the platen.
18. Remove the five screws that secure the Cutter Unit.
D) Silver, Phillips, Round Washer Head S-tite M3x6: five pieces
19. Slide the Cutter Unit to the right to detach the left side of it from the main body,
then disconnect the connector of the Cutter Motor.
20. Remove the Cutter Unit while pulling out the harness.
Be sure to refer to Chapter 5 "Adjustment"
A D J U S T M E N T
R E Q U I R E D
specified adjustments after replacing or removing the Cutter Unit.
<Adjustment Item>
1.
Cut Position Adjustment
DISASSEMBLY & ASSEMBLY
(see p283)
and perform
Disassembly and Assembly Procedure
Cutter Unit
Cutter Unit
Connector
Cutter Unit's Motor
Figure 4-95. Removing the Cutter Unit
Revision D
Cutter Unit
D
199