Absorber Position Check - Epson Stylus Pro 7710 Service Manual

Epson Stylus Pro 7700/7710/7900/7910/9700/9710/9900/9910

5.4.9 Absorber Position Check

This allows you to adjust the print position to the absorber (waste ink pad) for
borderless printing. (This is a check only)
PAPER USED
Size:
Epson Stylus Pro 9900/9910:44 inches
Epson Stylus Pro 7900/7910:24 inches
Type: Premium Glossy Photo Paper (250)
PROCEDURE
1. Turn the printer ON.
2. Press [Menu ] and enter the panel setting mode.
→
3. Select PRINTER SETUP PAPER SIZE CHECK
OFF.
4. Press [Paper Source ] to change the setting of cutting roll paper to OFF.
5. Turn the printer OFF.
6. Turn the printer ON in the Serviceman Mode.
Turn the power ON while pressing [Menu
simultaneously.
→
7. Select SELF TESTING Mecha Adjustment
8. Press [OK] while [Enter] Printing
The adjustment pattern will be printed.
9. Press [Paper Cut] and cut off the adjustment pattern.
10. Open the Front Cover (Middle).
ADJUSTMENT
and change the setting to
] + [Paper Feed ] + [OK]
→
Pad Position.
is displayed.
Head Related Adjustments
11. See Figure 5-60 and check if the standard line for the Waste Ink Pad for the
borderless printing is within the OK range.
Epson Stylus Pro 9900/9910:12 points
Epson Stylus Pro 7900/7910:8 points
This adjustment is performed on the factory. It cannot be adjusted
C A U T I O N
on the field.
12. Close the Front Cover (Middle), and turn the printer OFF.
The opposite side
Figure 5-59. Adjustment pattern
Checks for (1)
NG OK NG NG OK NG
Standard line Standard line
OK NG
Figure 5-60. Adjustment pattern (zoom)
Revision D
Home position
Checks for (2) or left
NG OK NG NG OK NG
Standard line Standard line
OK NG
332