Epson Stylus Pro 7710 Service Manual page 159

Epson Stylus Pro 7700/7710/7900/7910/9700/9710/9900/9910
4.4.2.16 Front Cover Sensor R
1. Remove the Control Panel. (p142)
2. Remove the IC Cover R and the IC Shaft Cover R.
3. Remove the Maintenance Tank R.
4. Remove the Right Cover. (p148)
5. Remove the Rear Cover. (p159)
6. Remove the Mid-Front Cover. (p196)
7. Remove the Front Cover (Lower).
8. Disconnect the connector (CN21) on the Main Board Assy.
9. Release the cable from the cable tie, clamp and the saddle.
10. Pull out the harness from the hole on the Main Frame.
11. Release the cable from the two clamps.
DISASSEMBLY & ASSEMBLY
(p145)
(p147)
(p200)
See Figure 4-33.
See Figure 4-34.
See Figure 4-34.
Disassembly and Assembly Procedure
- As seen from the rear -
Saddle
Clamp
Cable tie
Figure 4-33. Releasing the harnesses (rear)
- As seen from the front -
Clamps
Figure 4-34. Releasing the harnesses (front)
Revision D
Main Board Assy
CN21
Hole
160