Epson Stylus Pro 7710 Service Manual page 275

Epson Stylus Pro 7700/7710/7900/7910/9700/9710/9900/9910
9. Remove the four screws that secure the USB Housing Duct, and remove the USB
Housing Duct.
C) Silver, Phillips, Round Washer Head S-tite M3x10: four pieces
10. Remove the four screws that secure the plate.
D) Silver, Phillips, Bind P-tite M3x8: two pieces
E) Silver, Phillips, Round Washer Head S-tite M3x4: two pieces
11. Loosen the ten screws that secure the plate, and remove the plate.
F) Silver, Phillips, Round Washer Head S-tite M3x8 & spring: ten pairs
When removing the plate, take care in the following.
C A U T I O N
The screws (F) that secure the plate do not come off, just
become loosened.
Some of the screws have a spring attached at the tip; therefore,
make sure not to drop the springs when removing those screws.
When attaching the plate, align the screws and the screw holes
while checking them from the opening space so as not to drop the
springs.
Spring
Plate
12. Disconnect the relay connector, and release the harness from the clamps.
DISASSEMBLY & ASSEMBLY
Relay connector
Disassembly and Assembly Procedure
USB Housing Duct
Plate
Figure 4-211. Removing the plate
Clamps
Figure 4-212. Removing the Cooling Fan 2 (1)
Revision D
C
D
E
F
Cooling Fan 2
276