Epson Stylus Pro 7710 Service Manual page 89

Epson Stylus Pro 7700/7710/7900/7910/9700/9710/9900/9910
No. Message on LCD
44 TAKE-UP DISCONNECTED
SET AUTO TAKE-UP REEL SYSTEM IN
PRINTER AND RESTART THE PRINTER
45 TAKE-UP DISCONNECTED
AUTO TAKE-UP REEL UNIT IS DISCONNECTED
DO YOU CONTINUE?
NO
YES
46 TAKE-UP ERROR
CHECK THE STATUS OF AUTO TAKE-UP REEL
UNIT AND RESTART THE PRINTER
TAKE-UP ERROR
47
IS ANYTHING OBSTRUCTING THE TAKE-UP
REEL SENSOR SYSTEM?
LOAD PAPER AGAIN
48 SProofer DISCONNECTED
CONNECT SpectroProofer TO THE PRINTER
AND RESTART THE PRINTER
49 ILS20EP DISCONNECTED
REFER TO THE MANUAL AND CONNECT
ILS20EP TO SpectroProofer
RESTART THE PRINTER
50 SpectroProofer ERROR
REFER TO THE MANUAL TO FIND OUT HOW
TO SOLVE THE PROBLEM
NN
*NN is the error number.
SProofer DISCONNECTED
51
SpectroProofer IS DISCONNECTED
DO YOU CONTINUE?
NO
YES
TROUBLE SHOOTING
Description
Auto Take-up Reel Unit is not correctly installed in the
printer. Auto Take-up Unit is disconnected when the printer
is turned on.
Auto Take-up Reel Unit is not recognized.
Auto Take-up Reel Unit is not correctly installed in the
printer. This occurs at power-on, the Auto Take-up Reel
Unit was connected the last time the printer was on.
Auto Take-up Reel Unit is not recognized.
The roll paper is not set to the Auto Take-up Reel Unit
properly.
The Auto Take-up Reel Unit does not wind the paper.
The SpectroProofer is not connected to the printer properly. Turn the printer off, and then connect the SpectroProofer to the printer
The color measurement device (ILS20EP) is not connected
properly.
See 3.4 "Remedies for Error Messages related to SpectroProofer/Auto Take-up Reel"
The SpectroProofer is not connected to the printer properly. Select NO, and then turn the printer off, and then connect the
The SpectroProofer is not recognized.
Remedies for Error Messages
Remedy/Points to be checked
Turn the printer off, and then install the Auto Take-up Reel Unit
properly.
Replace the USB cable.
Replace the Main Board Assy or the Auto Take-up Reel Unit.
P.167, P.245)
Select NO, and turn the printer off, and then install the Auto Take-up
Reel Unit properly. If you select YES, the paper is ejected without
using the Auto Take-up Reel Unit.
Replace the USB cable.
Replace the Main Board Assy or the Auto Take-up Reel Unit.
P.167, P.245)
Press the button to release the paper presser, and then set the roll
paper to the Auto Take-up Reel Unit properly.
Check if there is some foreign material stuck on the sensor or the
reflector plate of the Auto Take-up Reel Unit, or some interruption of
the light by an obstacle.
properly.
Turn the printer off, and then connect the color measurement device
(ILS20EP) to the SpectroProofer properly.
(See P.92).
SpectroProofer to the printer properly. If you select YES, the printer
continues printing.
Check the connection between the Mount Sensor and the Main Board
Assy.
Replace the Mount Sensor with a new one.
Revision D
(See
(See
(See P.270)
90