Epson Stylus Pro 7710 Service Manual page 202
Large format color inkjet printer
Hide thumbs
Also See for Stylus Pro 7710:
- Service manual (519 pages) ,
- Network manual (43 pages) ,
- Unpacking and setup manual (30 pages)
Table of Contents
Advertisement
Epson Stylus Pro 7700/7710/7900/7910/9700/9710/9900/9910
4.4.5.9 PF Motor
1.
Remove the IC Cover L and the IC Shaft Cover L.
2.
Remove the Maintenance Tank L.
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7900/7910.
3.
Remove the Left Cover.
(p148)
4.
Disconnect the connector (CN303) on the Sub Board Assy; C.
5.
Release the harness from the tape, the clamps, and the cable retainer.
6.
Remove the three screws that secure the PF Motor Mounting Plate.
A) Silver, Phillips, Bind machine screw M4x8: three pieces
7.
Detach the PF Timing Belt from the drive pulley of the PF Motor, and remove the
PF Motor Mounting Plate.
DISASSEMBLY & ASSEMBLY
(p145)
(p147)
Disassembly and Assembly Procedure
- Rear left -
CN303
Sub Board Assy; C
Clamps
Figure 4-101. Releasing the harness
- Left side -
PF Motor Mounting Plate
Figure 4-102. Removing the PF Motor Mounting Plate
Revision D
Cable Retainer
Tape
PF Timing Belt
Drive pulley
A
203
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
