Epson Stylus Pro 7700/7710/7900/7910/9700/9710/9900/9910
MOUNTER ONLY TEST'S PROCEDURE
Preparation
1.
Start the inspection program.
2.
Connect the mounter to the computer with a USB cable.
3.
Turn on the mounter.
NOTE: To have the computer recognize the mounter, the wizard
screen is displayed, then click on the [Cancel] button.
4.
Select
MOUNTER ONLY TEST
Figure 5-90. [MOUNTER ONLY TEST] Menu Screen
ADJUSTMENT
from the inspection program.
Sensors check
1.
Select
Sensors check
2.
When the following screen appears, remove the mounter from the printer.
(It is OK to detach the right side of the mounter from the printer slightly.)
Figure 5-91. [Sensor check] Screen
3.
Click on the [OK] button.
4.
Confirm the blue screen appears, click on the [OK] button.
Figure 5-92. Confirmation Screen
Tests
from the inspection program.
Revision D
364