Epson Stylus Pro 7710 Service Manual page 163

Epson Stylus Pro 7700/7710/7900/7910/9700/9710/9900/9910
4.4.2.18 Cartridge Cover Sensor R
1. Remove the Control Panel. (p142)
2. Remove the IC Cover R and the IC Shaft Cover R.
3. Remove the Maintenance Tank R.
4. Remove the Right Cover. (p148)
5. Remove the Rear Cover. (p159)
6. Remove the Ink Cartridge Holder R.
7. Disengage the two hooks that secure the cover of the Head Board Assy R, and
remove the cover.
8. Disconnect the two connectors (CN408, CN409) on the Head Board Assy R.
9. Release the harness from the two hooks.
10. Remove the two screws that secure the Cartridge Cover Sensor R, and remove the
Cartridge Cover Sensor R.
A) Black, Phillips, Bind P-tite M3x10: two pieces
DISASSEMBLY & ASSEMBLY
(p145)
(p147)
(p216)
See Figure 4-40.
Disassembly and Assembly Procedure
- Right side -
Cover of Head Board Assy R
Hook
Figure 4-39. Removing the cover of the Head Board Assy R
Connectors
Hooks
Cartridge Cover Sensor R
Figure 4-40. Removing the Cartridge Cover Sensor R
Revision D
Hook
- Right side -
Head Board Assy R
A
164