Epson Stylus Pro 7710 Service Manual page 173

Epson Stylus Pro 7700/7710/7900/7910/9700/9710/9900/9910
4.4.3.5 Sub Board Assy; C
1. Remove the IC Cover L and the IC Shaft Cover L.
2. Remove the Maintenance Tank L.
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7900/7910.
3. Remove the Left Cover. (p148)
4. Disconnect all the cables and FFC on the Sub Board Assy; C.
5. Remove the three screws that secure the Sub Board Assy; C, and remove the Sub
Board Assy; C.
A) Silver, Phillips, Bind machine screw M3x6: four pieces
Connector assignment:
Connector No. Color
(FFC) Main Board Assy (CN300)
CN300
White Main Board Assy (CN301)
CN301
(FFC) PF Encoder Sensor
CN302
White PF Motor
CN303
White CR Motor
CN304
Maintenance Tank (L) (Epson Stylus Pro 9700/9710/9900/9910
(FFC)
CN305
only)
Red Cutter Unit
CN309
White Roller Release HP Sensor
CN310
Red Cutter Unit
CN311
DISASSEMBLY & ASSEMBLY
(p145)
(p147)
Destination
Disassembly and Assembly Procedure
CN300
CN310
CN311
CN305 CN302 CN307 CN303
Figure 4-53. Connector locations
- Left side -
Sub Board Assy; C
Figure 4-54. Removing the Sub Board Assy; C
Revision D
CN301
CN309
CN304
A
174