Fieldbus Device Commissioning; Getting Started; Read This First - Honeywell Series A User Manual

Fieldbus interface module

Hide thumbs Also See for Series A:

Table of Contents

7. Fieldbus Device Commissioning

This section outlines a typical process to follow to commission a fieldbus loop in an

Experion system. This section does not provide detailed procedures for each stage in the

process. Please reference appropriate sections in this document or applicable vendor

documentation for detailed information, if required.

The following table lists the topics included in this section. If you are viewing this

information online, just click the topic title to jump to the information location.

Connecting Devices

Checking Device

Checking Control Strategy

Flowchart Summary

Getting Started

The CIOM-A Fieldbus Interface Module (FIM) sets many parameters within a fieldbus

device during its initial setup and commissioning in an Experion system. While you can

change some parameters, such as calibration ones, when the device is being operated on a

workbench or at a location apart from the system, you must not change certain other

parameters. The following table outlines the functions you must consider before

commissioning a device.

For This Function. . .

Experion PKS Series A Fieldbus Interface Module User's Guide

Consider This . . .

Experion pks series a