16.1 Loading CIOM-A FIM firmware
ATTENTION
If the CIOM-A FIM is not installed and pre-configured by the factory, users
must load the CIOM-A FIM's firmware to make it fully operational. This is also
true for any replacement CIOM-A FIM ordered separately from the factory.
Use the following procedures to check and load the CIOM-A FIM firmware, if required.
TIP
If you have updated firmware in a Control Processor Module (CPM), you will
find that this procedure is almost identical.
Checking CIOM-A FIM firmware status
Step
1
Flip the switch on the Chassis
power supply to the ON
position.
R400
Experion PKS Series A Fieldbus Interface Module User's Guide
July 2010
16. Appendix G
Action
Applies power to the chassis and
installed modules initiate their "boot"
routines.
Honeywell
Result
519