Bluetooth Barcode Reader Setup; Mx7 Tecton With Label - LXE MX7 Tecton CE Reference Manual

Bluetooth Barcode Reader Setup

Bluetooth Barcode Reader Setup
Please refer to the Bluetooth scanner manufacturer's User Guide; it may be available on the manufacturer's web site. Contact
your LXE representative
LXEsupports several different types of barcode readers. This section describes the interaction and setup for a mobile Bluetooth
laser scanner or laser imager connected to the MX7 Tecton using Bluetooth functions.
Prerequisites
The MX7 Tecton has the Bluetooth hardware and software installed. An operating system upgrade may be required.
l
Contact your LXE representative
If the MX7 Tecton has a Bluetooth address identifier barcode label affixed, then Bluetooth hardware and software is
l
installed.
The mobile Bluetooth laser scanner / laser imager battery is fully charged.
l
The MX7 Tecton main battery is fully charged. Alternatively, the MX7 Tecton may be in a powered cradle or cabled to
l
AC/DC power.
Important: The barcode numbering examples in this segment are not real and should not be created nor scanned with a
l
Bluetooth scanner.
To open the LXEZ Pairing program, tap Start | Settings | Control Panel | Bluetooth or tap the Bluetooth icon on the
l
desktop or tap the Bluetooth icon in the taskbar.
Locate the barcode label, similar to the one shown above, attached to the MX7 Tecton. The label is the Bluetooth address
identifier for the MX7 Tecton.
The mobile Bluetooth scanner / imager requires this information before discovering, pairing, connecting or disconnecting can
occur.
Important: The MX7 Tecton Bluetooth address identifier label should remain protected from damage (rips, tears, spills,
soiling, erasure, etc.) at all times. It may be required when pairing, connecting, and disconnecting new Bluetooth barcode
readers.

MX7 Tecton with Label

If the MX7 Tecton has a Bluetooth address barcode label attached, follow these steps:
1. Scan the Bluetooth address barcode label, attached to the MX7 Tecton, with the LXE Bluetooth mobile scanner.
2. If this is the first time the Bluetooth scanner has scanned the MX7 Tecton Bluetooth label, the devices are paired. See
section titled "Bluetooth Beep and LED
3. Open the LXEZ Pairing panel (Start | Settings | Control Panel | Bluetooth).
4. Tap Discover. Locate the Bluetooth scanner in the Discovery panel.
5. Double-tap the stylus on the Bluetooth scanner. The right-mouse-click menu appears.
6. Select Pair as Scanner to pair the MX7 Tecton with the Bluetooth mobile scanner.
The devices are paired. The Bluetooth barcode reader responds with a series of beeps and an LED flashes. Refer to the
following section titled "Bluetooth Beep and LED
Note: After scanning the MX7 Tecton Bluetooth label, if there is no beep and no LED flash from the Bluetooth device, the
devices are currently paired.
for Bluetooth product assistance.
for details.
Sample Bluetooth Address Barcode Label
Indications". If the devices do not pair successfully, go to the next step.
Indications".
E-EQ-MX7CERG-A [ 112 ] MX7 Tecton™ CE Reference Guide