Offsite Phone Operation; Central Station Communication - GE Simon XT Installation Manual

Offsite phone operation

Test the system from a remote phone by calling the panel and using the commands
in Table 28 below.
Table 28: Phone commands
System function
Disarm
Arm doors/windows
Arm motion sensors
Arm doors/windows with no entry delay
Arm motion sensors with latchkey
Arm doors/windows and motion sensors
Arm doors/windows with no entry delay and
motion sensors with latchkey
Specific light on
Specific light off
All lights on
All lights off
System status
Audio verification
Terminate session

Central station communication

After performing sensor and communication tests, check that the system is reporting
alarms successfully to the central station. Table 29 on page 48 provides a list of
sensor/user report codes.
To test communication with the central station:
1. Call the central station and tell the operator that you will be testing the system.
2. Arm the system.
3. Test each of the wireless panic buttons and trip at least one sensor of each type
(fire, intrusion, etc.) to verify that the appropriate alarms are working correctly.
4. When you finish testing the system, call the central station to verify that the
alarms were received.
Simon XT Installation Manual
Phone command
1
2
3
2 2
3 3
2 3
2 2 3 3
*, <unit number>
#, <unit number>
* *
# #
0
5 plus X (X= a command from Audio Verification
Set)
9
47