Installing Optional Snapcards; Installing Optional Hardwire Input Modules (Hims) - GE 60-806-95R-16Z - Security Concord Express System Control Panel Installation Instructions Manual

Note
For best results, it is recom-
mended that you crimp a
spade lug on the wire end at
the panel and secure the lug
under the circuit board
screw as shown in Figure .
Note
Use of the HIM with the
Concord™ Express panel
has not been investigated by
UL.
Installing the System
Antenna Loop
Pipe
Water Pipe
Ground Clamp
Figure 5. Connecting the Panel to Earth Ground

Installing Optional SnapCards

The SnapCard Header on the lower-left side of the panel accepts one of the following SnapCard
models:
• 8Z Input SnapCard—60-757
• 4 Output SnapCard—60-758
• 4Z Input/2 Output Combo SnapCard—60-756
Install the desired SnapCard onto the panel SnapCard Header and secure it in place with two
screws, included with the card (Figure 6).
Connect all necessary input/output wiring using the installation instructions included with the
SnapCard.
Push SnapCard Connector
Onto Panel Header
Figure 6. Installing a SnapCard

Installing Optional Hardwire Input Modules (HIMs)

Each SuperBus 2000 8-Zone Input Module (60-774) adds eight supervised hardwire zones to the
system. Both normally open and normally closed detectors can be wired to module inputs (see
Figure 8).
Connect all necessary input/output wiring using the installation instructions included with the
HIM.
Knockout
Secure SnapCard with
Two Screws
8