Table of Contents
Advertisement
Euro Simon Security System
Adding (Learning) Sensors
These instructions describe how to add sensors, touchpads and other system devices into panel
memory. The panel recognizes a sensor when you press a sensor program button, press and
release a tamper switch, press a sensor test button, or put a sensor into alarm.
Note
The hardwire inputs must have sirens or hardwire sensors with 47k Ohm resistors connected between
the DCOUT and HWIN1 or HWIN2 terminals before learning in a sensor. If one of these connections is
not made, the panel will learn in a hardwire zone.
Note
If you are installing a sensor on a gun case, jewelry box, or similar usage, and the sensor is active in
level one, you must sub-disarm to avoid putting the panel into alarm when the sensor and the magnet
are separated.
The following table, "Device Programming," describes the programming button location for
each device
Device
Door/Window Sensor
Motion Sensor
Smoke Sensor
Keychain Touchpad
Remote Handheld Touchpad
Hardwire Sensors
Freeze & Water
When adding (learning) sensors, the panel uses an ascending numbering sequence starting with
1. You can override this by entering the desired sensor number using the numbered keys.
Use the Table in Appendix B, which was filled out during the system plan
Device Programming
To Program
Press button on top of sensor (cover removed) or trip tamper
Press button on back of sensor (mounting plate removed) or
trip tamper
Trip tamper, press test button, remove from base or put sen-
sor in alarm
Press and hold Lock & Unlock buttons together
Press the EMERGENCY buttons
Separate sensor from magnet
Trip tamper or press and hold button on top of the sensor
(cover removed) until control panel confirms program-
ming. If button is not held down long enough, SYSTEM
STATUS reports sensor as open.
14
Advertisement
Table of Contents
