Alarm Sirens And Lamp Modules; Panel Indicator Lights; Numeric Pager - GE Simon Security System User Manual

Simon Security System

Alarm Sirens and Lamp Modules

Exterior and interior sirens make 3 different alarm sounds on the premises, each indi-
cating a different type of alarm. Sirens are programmed by the installer to time-out and
stop sounding after a specified time.
Use the following table to understand the siren sounds used by the security system.
Temporal 3 refers to a continuous pattern of 3 siren pulses then off for 1.5 seconds, 3
siren pulses then off for 1.5 seconds.
Alarm Siren and X10 Light Information
X10 Lights
X10 Siren
Interior & Panel Siren
Exterior Siren

Panel Indicator Lights

Use the following table to understand the panel indicator lights.
Button
Arm Doors & Windows
Arm Motion Sensors
Disarm
System Status
Chime Doors
Chime Special Motion
Time Lights
Sensor Lights

Numeric Pager

You may program your security system to send a numeric message indicating system
activities to your pager. The system will send the message twice. See "Programming
Instructions".
Use the following table to determine what the numeric message is reporting.
Reports
Phone Test -101 -101
Fire Intrusion
Steady Flashing
Steady Steady
Temporal 3 Steady
Temporal 3 Steady
Panel Indicator Lights
When the Button Light is
On
Doors/Windows armed
Motion Sensors armed
System disarmed
System trouble or Open Sen-
sor
Door will cause chime
Motion will cause chime
Time activated lights on
Sensor activated lights on
Numeric Pager Reporting
Numeric
Reports
Message
Fail to Open
Emergency
Steady
Alarm beeps
Fast on/off
When the Button
Flashes
Doors/Windows armed
& No Entry Delay on
Motion Sensors armed
& Latchkey on
System subdisarmed
System in alarm
_________________
_________________
_________________
_________________
Numeric
Message
-112 -112
9