Upgrading The Version At Normality - Zte ZXR10 5900 Series User Manual

8. Check for the new version file in the Flash. If not found, the
copying failed, when must repeat step 8 to copy the version
again.
9. Reboot ZXR10 5900/5200, and follow step 4 to change the
boot mode to booting from Flash, when Boot path changes to
/flash/img/zxr10.zar automatically.
Note:
can also change the boot mode to booting form Flash with the
nvram imgfile-location local command in the global config-
uration mode.
10. Type @ at the prompt ZXR10 Boot: and press ENTER to boot
the system with the new version in the Flash.
11. When the system is booted successfully, check the running ver-
sion to confirm the success of upgrade.

Upgrading the Version at Normality

Upgrade the software version in several different ways when the
switch is working properly, including copying the version to the
switch acting as an FTP/TFTP client and remote upgrade over FTP.
The local upgrade procedure is as follows when the switch serving
as an FTP client.
1. Connect the ZXR10 5900/5200's console port (on the main
control board) to the serial port of the background host with a
console cable attached to the switch; connect the management
Ethernet port (10/100 M Ethernet port on the main control
board) to the background host's network port with a straight
through network cable. Make sure that both connections are
correct.
2. Set the background host for upgrade to be in the network seg-
ment as the switch's management Ethernet port, so that the
background host can ping the management Ethernet port.
3. Refer to FTP/TFTP Overview
4. View the running version.
5. Use Delete command to the old version file from the Flash's
IMG directory with the delete command. If there is enough
space in the Flash, you can also reserve the old version with
another name.
6. Copy the new version file on the background FTP server to the
Flash's IMG directory with the filename as zxr10.zar.
7. Check for the new version file in the Flash's IMG directory. If
the new version file is not found, the copy failed. The user
must repeat step 5 to copy the version again.
8. When the system is rebooted successfully, check the running
version to confirm the success of upgrade.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 3 System Management
, Start the background FTP server
25