Configuring Ztp Topology Collection Protocol - Zte ZXR10 5900 Series User Manual

ZXR10 5900/5200 Series User Manual (Basic Configuration Volume)
Command
zdp holdtime <time>
ZXR10(config)#
Command
ztp enable
ZXR10(config)#
Command
ztp vlan <vlanId>
ZXR10(config)#
Command
ztp hop <number>
ZXR10(config)#
Command
ztp hop-delay <time>
ZXR10(config)#
Command
ztp port-delay <time>
ZXR10(config)#
146 Confidential and Proprietary Information of ZTE CORPORATION
Configuring ZTP Topology Collection
Protocol
1. To enable the ZTP
the following command.
2. To conduct ZTP topology collection on different VLANs, use the
following command.
3. To set the hops of ZTP topology collection, use the following
command.
4. To set each hop delay in sending ZTP protocol packets, use the
following command.
5. To set delay in sending ZTP protocol packets on the port, use
the following command.
6. To conduct once topology collection, use the following com-
mand.
Function
This configures the valid holding
time of ZDP information.
function globally or in specific interface, use
Function
This enables the ZTP function
globally or in specific interface.
Function
This conducts ZTP topology
collection on different VLANs.
Function
This sets the hops of ZTP
topology collection.
Function
This sets each hop delay in
sending ZTP protocol packets.
Function
This sets delay in sending ZTP
protocol packets on the port.