Zte ZXR10 5900 Series User Manual page 131

Command
snmp-server access-list <acl-number>
ZXR10(config)#
Command
snmp-server context < context name >
ZXR10(config)#
Command
snmp-server engine-id <engine-id>
ZXR10(config)#
Command
snmp-server group <groupname>
ZXR10(config)#
v3 {auth|noauth|priv}[context <context-name>
match-prefix|match-exact ][read <readview>][write
<writeview>][notify <notifyview>]
Command
snmp-server packetsize <484-1400>
ZXR10(config)#
Command
snmp-server trap-source <IP address>
ZXR10(config)#
ZXR10 5900/5200 supports five kinds of ordinary traps: SNMP,
bgp, OSPF, RMON and stalarm.
7. To use ACL to control the host that can access the switches
through SNMP protocol, use the following command.
8. To define context name of SNMP, use the following command.
9. To set local engine id of SNMPv3, use the following command.
10. To configure safe mode group of user, use the following com-
mand.
11. To set the maximum packet size of SNMP, use the following
command.
12. To configure TRAP source, use the following command.
13. To configure the users which are allowed to access SNMP
engine, use the following command.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 11 Network Management Configuration
Function
This uses ACL to control the host
that can access the switches
through SNMP protocol.
Function
This defines context name of
SNMP.
Function
This sets local engine id of
SNMPv3.
Function
This configures safe mode group
of user.
Function
This sest the maximum packet
size of SNMP.
Function
This configures TRAP source.
117