Dom Configuration; Dom Function Overview - Zte ZXR10 5900 Series User Manual

ZXR10 5900/5200 Series User Manual (Basic Configuration Volume)
42 Confidential and Proprietary Information of ZTE CORPORATION
F 17 P L
IGURE ORT OOPBACK
Configuration of Switch A:
ZXR10(config)#interface gei_1/1
ZXR10(config-gei_1/1)#switchport mode trunk
ZXR10(config-gei_1/1)#switchport trunk vlan 1-2
ZXR10(config-gei_1/1)#exit
ZXR10(config)#loop-detect interface gei_1/1 enable
ZXR10(config)#loop-detect protect-interface gei_1/1 enable
ZXR10(config)#loop-detect reopen-time 5
ZXR10(config)#loop-detect interface gei_1/1 vlan 1-2 enable
This displays detail of port which enables loopback detection.
ZXR10(config)#show loop-detect interface
gei_1/1
ZXR10(config)#show loop-detect interface-detail
isUp isMonitor
Yes Yes
reopenTime loopvlan
300 2

DOM Configuration

DOM Function Overview

DOMdigital optical monitoring is a part of optical module specifica-
tion. The optical module with DOM function can read temperature,
voltage, current, sending and receiving power of optical module.
In addition, each optical module sets some threshold values of
module (include alarm threshold and warning threshold ) when
leaving the factory. After DOM function is enabled, the module
running state value can be polled by I2C bus of optical module. It
is compared with threshold value. When the current value exceeds
the threshold value that manufacturer sets, the alarm will be sent
by syslog and SNMP trap.
D E
ETECTION XAMPLE
isLoop isProtected
Yes
vlanRange
1-2
gei_1/1
Yes