Cluster Management Configuration Example; Cluster Management Maintenance And Diagnosis - Zte ZXR10 5900 Series User Manual

Cluster Management
Configuration Example
Connect two devices to implement cluster management, as shown
in Figure 33.
F 33 CLUSTER MANAGEMENT CONFIGURATION
IGURE
Configuration steps are as follows:
1. Ensure that two ports are in a VLAN (configured as vlan1 and
ensure that vlan1 does not configure Layer 3 address).
2. Execute show zdp neighbor on DUT A and ensure zdp neighbor
is already set up.
3. Execute ztp start on DUT A to conduct topology collection, and
then execute show ztp device-list to view DUT A and DUT B.
4. Configure DUT A as the command switch with group switch-
type command. View whether DUT A has become the com-
mand switch with show group command.
5. Configure DUT B as the member switch with group member
device 1 command and then view Member 1 in the up state
with the show group member command on DUT A.
6. Log in to Member 1 with the rlogin member 1 command in the
privilege mode, and log in from Member 1 to the command
switch with the rlogin commander command on DUT A.
Cluster Management
Maintenance and Diagnosis
When encountering cluster management problem, we can locate
the fault and remove them with relevant debugging commands.
Among these commands, show command and debug command
may be used.
Command show can be used to view current cluster configuration
information.
1. To display ZDP configuration information, use the following
command.
show zdp
2. To view ZTP configuration information, use the following com-
mand.
show ztp
3. To display cluster configuration information, use the following
command.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 13 Cluster Management Configuration
149