Zte ZXR10 5900 Series User Manual page 22

ZXR10 5900/5200 Series User Manual (Basic Configuration Volume)
8 Confidential and Proprietary Information of ZTE CORPORATION
i. Configure the Telnet login user name and password through
the console port.
ii. Configure the Telnet login user name and password through
the console port.
iii. Connect the host network port to the Ethernet port of the
switch.
iv. Set the host IP address to one in the same network seg-
ment as that of the VLAN interface so that the host can ping
the IP address of the VLAN interface.
v. Run the telnet command on the host and input the IP ad-
dress of the VLAN interface to log in to the switch, as shown
inFigure 7 .
F 7 RUN TELNET
IGURE
vi. Click OK to enter the interface as shown
F 8 TELNET LOGIN
IGURE
vii.Type the correct user name and password at the prompt to
enter into switch configuration status.
inFigure 8 .